Standing on the shoulders of giants is how one customer described studying with the ITExamDownload 922-094 bank: Nortel Communication Server 1000 Rls.5.0 Dialing Plan Design and IP knowledge assembled by specialists, refined by regular research, and delivered with service that treats your success as its own job.
Nortel 922-094 Exam Syllabus Topics:
| Section | Objectives |
|---|---|
| Topic 1: Signaling Server Administration | - Element Manager configuration - Primary vs Alternate Signaling Server - Database synchronization and failover |
| Topic 2: IP Networking in CS 1000 Rls.5.0 | - Routing and Steering Codes
|
| Topic 3: Dial Plan Configuration and ESN | - Network Numbering and Call Routing - Electronic Switched Network (ESN) parameters
|
| Topic 4: Dialing Plan Design | - Coordinated Dialing Plan (CDP) - Flexible Numbering Plan (FNP) - Network Attendant and Location-based Routing - Uniform Dialing Plan (UDP) |
922-094 Exam Facts and the Service Behind Them
- Signaling Server Administration ()
- Dialing Plan Design ()
- Dial Plan Configuration and ESN ()
Nortel Communication Server 1000 Rls.5.0 Dialing Plan Design and IP Sample Questions:
During a planned work activity, the customer powered off the Primary Signaling Server on a
Communication Server 1000 Rls. 5.0 system. Following the work activity, some IP telephones were unreachable, and they appeared to have old Directory Numbers assigned to them. Which database configuration parameter would you check on the Alternate
Signaling Server within the Network Routing Service?
- A. verify that the Alternate Gatekeeper is configured for automatic database synchronization
- B. verify the re-boot of the Alternate Signaling Server and that the BIOS command is invoked
- C. verify that the Alternate Signaling Server is defined for Fail-safe situations
- D. verify that the Signaling Server is defined as the Alternate Signaling Server
Correct Answer: A 🗳️
A company recently deployed IP telephones in its Call Center. During peak traffic conditions, callers receive an overflow tone and calls are blocked.
Assume the following settings:
Zone Number = 1
Zone Intent = MO
Intrazone Traffic = Best Quality
Interzone Traffic = Best Bandwidth
Resource Type = Shared
Which programming change is recommended in Element Manager (LD 117) to provide dedicated Digital Signal Processor (DSP) resources to Contact Center IP telephones?
- A. Change Intrazone Traffic to Best Bandwidth
- B. Change Zone Intent to VTRK
- C. Change Resource Type to Private
- D. Change Interzone Traffic to Best Quality
Correct Answer: C 🗳️
You are configuring a bandwidth management zone on a Communication Server 1000 Rls.
5.0 Call Server using Element Manager (LD 117). The Call Server zones will be used for
Intrazone communications between endpoints (IP telephones and gateways). Which is the preferred bandwidth management strategy, assuming the network has adequate bandwidth?
- A. Best Quality (BQ)
- B. Best Effort (BE)
- C. Allocated Bandwidth (AB)
- D. Best Bandwidth (BB)
Correct Answer: A 🗳️
Viewing page 1 out of 10 pages.
Viewing questions 1-3 out of 30 questions.



